DISASSEMBLY INSTRUCTIONS
1. REMOVAL OF ANODE CAP3. After one side is removed, pull in the opposite direction to
remove the other.
Read the following NOTED items before starting work.
NOTE
* After turning the power off there might still be a potential
Take care not to damage the Rubber Cap.
voltage that is very dangerous. When removing the
Anode Cap, make sure to discharge the Anode Cap'sINSTALLATION
potential voltage.
1. Clean the spot where the cap was located with a small
* Do not use pliers to loosen or tighten the Anode Cap
amount of alcohol. (Refer to Fig. 1-3.)
terminal, this may cause the spring to be damaged.
REMOVAL
1. Follow the steps as follows to discharge the Anode Cap.Location of Anode Cap
(Refer to Fig. 1-1.)
Connect one end of an Alligator Clip to the metal part of a
flat-blade screwdriver and the other end to ground.
While holding the plastic part of the insulated Screwdriver,
touch the support of the Anode with the tip of the
Screwdriver.
A cracking noise will be heard as the voltage is discharged.
GND on the CRT
Fig. 1-3
NOTE
Confirm that there is no dirt, dust, etc. at the spot where
the cap was located.
2.Arrange the wire of the Anode Cap and make sure the
wire is not twisted.
3.Turn over the Rubber Cap. (Refer to Fig. 1-4.)
ScrewdriverCRT
Support
Alligator Clip
GND on the CRT
Fig. 1-1
2.Flip up the sides of the Rubber Cap in the direction of theFig. 1-4
arrow and remove one side of the support.
(Refer to Fig. 1-2.)
4. Insert one end of the Anode Support into the anode button,
then the other as shown in Fig. 1-5.
Rubber Cap
CRT
Support
Fig. 1-2Support
CRT
Fig. 1-5
5.Confirm that the Support is securely connected.
6.Put on the Rubber Cap without moving any parts.
B1-1 |